Seagull cassutt 3M Racer Spezifikationen Seite 1

1www.seagullmodels.comASSEMBLY MANUALMS:X164Specifications:Wing span -----------------------------35in (89cm).Wing area ---------------303.8sq.in (19.

MINI CASSUTT 3M RACER Instruction Manual.10M3 x 12mm.Electric motor.4mm. ELECTRIC POWER ASSEMBLY.1) Locate

11www.seagullmodels.comBattery.2200mAh-2600mAh.Speed control.4) Attach the speed control to the side of themotor box using two-sided tape and tie wra

MINI CASSUTT 3M RACER Instruction Manual.12INSTALLING THE SPINNER. Install the spinner backplate, propelle

13www.seagullmodels.comPen.Remove covering. 8) Using a modeling knife, carefully re-move the covering that overlaps the stabilizermounting platform s

MINI CASSUTT 3M RACER Instruction Manual.14 5) Slide the vertical stabilizer back inplace. Using a triangl

15www.seagullmodels.comRudder control horn.Elevator control horn.480mm.480mm.AILERON PUSHROD HORN INSTALLATION50mm.Elevator pushrod.Rudder pushrod.

MINI CASSUTT 3M RACER Instruction Manual.16INSTALLATION PILOT.1) A scale pilot is included with this ARF. T

17www.seagullmodels.comBALANCING.  1) It is critical that your airplane bebalanced correctly. Improper balance willcause your plane to lose control

MINI CASSUTT 3M RACER Instruction Manual.18With the wing attached to the fuselage, all partsof the model ins

19www.seagullmodels.com 7) Check the receiver antenna. It shouldbe fully extended and not coiled up inside thefuselage. 5) If your radio transmitte

MINI CASSUTT 3M RACER Instruction Manual.2INTRODUCTION.Thank you for choosing the MINI CASSUTT 3M RACER AR

3www.seagullmodels.comKIT CONTENTS.1.Fuselage2.Wing Set3.Tail Set4.Canopy5.Cowling6.Wing Tube7.Main landing gear8.Fiberglass wheel pants9.Wheels10.Har

MINI CASSUTT 3M RACER Instruction Manual.4 8) After both ailerons are securely hinged,firmly grasp the win

5www.seagullmodels.comHINGING THE RUDDER. Glue the rudder hinges in place using thesame techniques used to hinge the ailerons.INSTALL THE AILERONS

MINI CASSUTT 3M RACER Instruction Manual.6INSTALLING THE FUSELAGE SERVOS. 1) Install the rubber grommets an

7www.seagullmodels.com 3) You have to trim each axle using a tollcutting and cut-off wheel.Caution when cutting the axles and wearprotective goggle

MINI CASSUTT 3M RACER Instruction Manual.8Servos.Small weight.Thread.INSTALLING THE AILERON.2) Place the se

9www.seagullmodels.com8) A string has been provided in the wing topull the aileron lead through to the wing root.Remove the string from the wing at t